Blushd = Blush + Lush Hybrid (Crush/Rush remixes) = Diana Mag Crush!

Currently non-functional pending pusher updates. The Diana feed lips are much tighter than Talon mags. Will likely use ½" brass pusher.

Print all files from Blush except for Lower, Mid Body, Mag Release, and Ram Body. Print all three Lush Mag Release parts.
 

Hardware:
Lush Mag Release:  Uses 2x m2.6 nerf screws, and a m3x15 screw (with the existing mag release spring)

Blush Additional hardware:
qty 1: M3 x 8 for the fourth attachment point on the rear cap
qty 2: M3 x 12 (or longer) screws for adjustment wrench
qty 3: 6-32 x 11.1" threaded rod. Just buy a 12" piece and cut it down after things are threaded in. 
qty 5: m3 brass insert
qty 1: 60mm length of 9/16" brass.

qty 2-3: -016 o-ring for barrel sealing and alignment. 
qty 1: -113 o-ring for pusher seal. 

For remaining HW fallow Crush notes.