Sanwa Snap-in Arcade Button Remover (30mm & 24mm)

Introduction

Simple stuff.  Push it flush with the panel to push the snap-in clips, and you can use a finger to push the button out.  I made one in both 30mm and 24mm.  Makes my life just a little easier.

Works for Sanwas--can't confirm with other button types.

Printing Suggestions

• 3 Walls / 100% infill / No supports
• Only tested in PLA, but any material will be fine
• Print with the thicker side facing the build plate
• Enable polyholes in Slicer if available to ensure the diameter of the inner circle doesn’t shrink too much. Not required, but could make a difference.