Remixed Ender3 5015 Fan Shroud with probe and strain relief

I like this design of a magnetic fan shroud with clean design so I've made some changes for my own use:

• added inductor probe mount (12mm diameter).
• Added strain relief. The original design leave a sizable hole at the top so hotend power and thermistor wires move so much they will broke off after some times.

Shroud is JdogAwesome's design without any changes, just included for completeness. Also, I've only tested on Ender3, not sure if it'll fit other versions.

Print settings:

• You'll need to rotate the design 90 degree, the side that contact X axis plate should be the bottom.
• Support is only needed for the overhang under the heatsink. You can even print without support and it won't turn out too bad