eSUN dryer holder for Prusa MK3S or MK4S

Pattern from the website: https://www.thingiverse.com/thing:4904219

Drawn for eSUN eBOX Lite dryer. I've added cutouts for buttons.

Printing time for both parts is 12 hours.

EDIT: After several days of use, I noticed that I made too large an angle between the dryer base and the vertical (it was 120% as in the original), therefore the filament spool inserted into the dryer tends to slightly lean towards the front wall (the spool touches only one rollers and rests against the front wall). I'm throwing in the second version, where I reduced the above-mentioned angle to 100 °. I haven't reprinted the parts yet, but hopefully this problem won't occur. I leave both versions of the files.

Greetings.

EDIT 04-02-2023: I forgot to write that you should add supports to print the model correctly. I printed without supports, but it will be nicer with supports.

EDIT 20-08-2025:  As suggested in the comments, I modified the model so that it could be printed without supports. I removed the chamfer at the back of the model. Now the model can be laid flat on the table. After some consideration, I decided not to make a hole there, as only a small amount of filament is needed to fill the chamfer. I also changed the dryer angle to 90 degrees, parallel to printer bed. Any suggestion are welcom.