The bottom part of the CHEETAH enclosure is split into two to achieve a total width of 380mm.
Assembly
This uses the same screws as the original CHEETAH
Printing Suggestions
4 Walls / 20% Cubic Infill / No Supports
Set “Top Surface” to 80% to ensure there is no over-extrusion, and to achieve a very smooth surface. Or use ironing--if you have it dialed in.
Only tested in PLA, but other materials should work--provided they have minimal warping/shrinkage
Designed for 220mm x 220mm x 250mm build volume
The flattest part of the model should face the bed
Recommend an enclosed 3d printer. The sharp corners of the body will likely lift from the build plate as the filament cools. Additionally ensure good adhesion to the build plate.
Or, use mouse ears on the sharp corners.
MISC
Also compatible with the non-OS version of the CHEETAH.
RAF
