Alien HueForge

Picture source - author: Brett Voutier  @brettvoutier

Then used HueForge v0.8.1 to create the model.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.

Two version size model/profile, the first is 200x200 and the second 150x150mm. The color change settings are identical. Or you can modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct.  You may print at higher layer heights below the Min Depth of 0.64mm. The Max Depth is 2.2mm and the Actual Depth is 2.2mm

It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.

TIP : The print is perfect also in black and white (skip the orange). Or you can replace the orange with red is good too, And version wiht very light blue (ice blue) or ligh green looks great too. Perfect is with glow filaments, but here skip the white completely - the glow filament start at the orange position.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use.

Filaments Used:
PLA Elegoo+ Black Transmission Distance: 0.3
PLA BambuLab Basic Orange Transmission Distance: 4.8
PLA Elegoo Matt White Transmission Distance: 6
This print uses 3 unique filaments
 

Swap Instructions:
 Start with Black
 At layer #9 (0.8mm) swap to Orange
 At layer #14 (1.2mm) swap to White for the rest.