Fly without your iPhone/iPad/Android mobile device hitting the floor next time out

Have you ever set up your mobile device on the seat tray just so only to have the tray move and cause your device to fall to the floor? Do you need a compact adjustable mobile stand while you are traveling? Do you spend your flight time on Boeing 737’s? Want to make your seat mates envious? Then this print may be for you!

The two bar grabs have two steps. They rotate down 90 degrees, and then slide in the direction of the arrow once rotated. This keeps them from flipping back up when in use. Do the opposite to close. These are what keeps the stand in place as the tray moves in and out.

You do not need to be on a airplane to use it. Works just as well on a flat surface without deploying the flip out bar grabs. The clod in front of you is just itching to knock everything out of place by reclining so leave some clearance away from the seat to keep that from happening.

Print flat with no supports. The hinges will be tight the first time through. Have successfully printed in both PLA and PETG with a 0.4 mm nozzle and various layer heights. Press down where the arrows are to get the top hinges going. Push upward above the plane to get the easel to open. Push from below on the 747 to get it to rotate.