January 16, 2022
Description
To make my Ikea lack enclosure fit under a shelf above it, i had to lower it. I did this by cutting some length of the lower table's legs. This revealed a hollow leg that doesn't look good and could potentially scratch the floor. To fix this issue i made these table leg feet that pressure fit on the legs.
V1: This version has holes for screws.
V2: I found that V1 pressure fit to the legs and didn't need the screws, so I removed the mount.
Step 1: push the part on the table leg on a 45° angle.
Step 2: rotate the part so that the complete leg is in it, then push down to pressure fit it over the leg
Category: 3D Printer AccessoriesLicense:
Creative Commons — Attribution — Noncommercial
7
Joey_3D
