Darlekian Coffee Tamper

Tamper that allows you to adjust the tamp compactness. (For 52mm portafilter)

Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: Doesn't Matter

Supports: No

Resolution:.2mm

Infill: 20%

Filament: ANY PLA or PETG Your choice 
 

Notes: 

1. Print two rings
2. PLA will likely warp in a dishwasher. PETG will likely not. However, either may contain constituents that may come adrift during dishwashing and may be carcinogenic. Therefore, it would be safer to hand wash.
3. CAP thread will perform better at 0.1mm. If your slicer has variable layer heights, use this feature.

Post-Printing

1. Clean off excess plastic with a knife, needle file and sandpaper.
2. If you want the tamper to feel heavy, fill the barrel with ball bearings, sand, plaster or the like. Then seal tightly.
3. Screw on rings keeping the flat edge closest to the barrel end. The ring is designed to come in contact with the lip of the portafilter to limit pressure

Category: Kitchen & Dining