leatherman 4mm bit adapter REMIX

SO i was having problems getting the bit hole sized appropriately with a 0.6 nozzle and after i made it easy to insert and remove, the next problem i had was it would fall out when i tipped it upside-down. So I made it easier to print without supports and I added a slot to drop a 3x1mm magnet into. if you have steel nozzle, you'll want to glue the magnet in, with a brass you should be fine. Set a print pause in your slicer at 13mm layer height and drop the magnet in.

print settings 0.6 nozzle, petg, 0.32 layers, 3 shells, no supports

Category: DIY