Peg Board wire holder

Holds spools of wire to a pegboard.

Prints best with supports

Wooden dowels:

I use barbecue skewers or chopsticks. Any stick smaller than 5/16 inch (9mm) diameter should work.

Pegboard attachment points:

For most strength, print with the 'side' down.

Based on the pegboard holders from "Make Anything's" youtube video

Print instructions

Category: Tool Holders & Boxes Print Settings

Printer Brand: Prusa

Printer: i3 MK2S

Rafts: No

Supports: Yes

Infill: light (15%)

Notes:

Draft - 0.3mm
Infill - Light (15%)
Supports - Yes

You could print slower and with more infill, but these settings are plenty strong. Took about 45 minutes to print each part.