E-Revo 1/16 Upright

This is printed replacement for the Mini E-Revo 1/16 front and rear uprights / steering knuckles. 

It uses threaded Nuts to set the backlash of the spherical upper and lower wishbone joints. Take care that you dont overtighten the nuts to prevent excessive binding and steering forces. 
Loctite for the thread is a good option to prevent them from loosening. You can also add a spot of grease to the spherical joints to reduce friction.

Parts are currently in test phase and have been printed with Prusament PC-CF on a 0.4mm nozzle and a layer height of 0.1mm.
10 Top/Bottom Layers
4 Perimeters
40% Infill 

no supports needed

Make sure you have your filament properly tuned as the parts require good dimensional accuracy for a proper fit of the wheel bearings.

2024-03-08: Added .stp-files of anyone wants to adapt to personal needs.