Floating Pot of Gold

This model utilizes the Magnetic Levitation kit from Bambu Lab.

Wow your friends and family by showing them that you've got your own pot of gold and THEY CAN'T HAVE IT!

Printing Instructions:

The 3mf file provided was sliced using Bambu Studio and should have all the proper settings as defined below

Gold

• Layer height: 0.12mm
• Wall type: Arachne
• Supports: Yes Clouds
• Supports: Yes Everything else:
• Supports: No
• Layer height: 0.2mm

To reduce weight in Pot.stl I put a modifier for the top portion of it and set infill to 0% (Open 3mf file in Bambu Studio/Orca Slicer to see what I mean)

Assembly Instructions:

Follow this video for assembly if needed.

• Place puck into Puck Container
• Screw Puck Cap onto it to secure it. There shouldn't be any rattling when it's screwed on all the way
• Screw puck assembly into Pot. Use Tool to tighten it sufficiently. It doesn't have to be super tight, but we don't want it to be loose either
• Feed power port wire through hole of Clouds
• Fasten power port using the provided nut
• Plug the power port into the levitating kit
• Slide clouds over Base
• Glue standoffs onto base
• Press bowties into corresponding slots. Do not use glue. It should be a press fit and should be difficult to remove
• Use double-sided tape to place the pcb sensor onto the flat section of the underside of the clouds (Refer to video if confused). This will be used to turn the lights on and off. Touching the outside of the cloud should be sufficient to control it
• Plug it in and place the pot on top of the clouds for it to levitate.

Don't be afraid to give me feedback if you feel something can be improved!

For those who have joined my club at the “Obsessor” tier or have subscribed to my commercial membership on Patreon, prints of this model can be used for commercial purposes.

Feel free to join my discord for additional support, questions, or suggestions!