Riser brace for Formd/Ncase T1

This was not my idea.

Dimensions: 165mm long, 155mm between center of holes, 10mm wide, 5mm thick, 3.4mm holes(⌀).

You could make it one or two mm thinner but I think that would work better with a stronger material like CNCed alluminum. I used ASA. I tested this one using two stacked 12+6mm standoffs on either side and M3x8mm countersunk screws. There is a fraction of a mm of space left in between the riser brace and the stock riser. You could optimize the design further, put some kind thin pad in between or use 1mm shorter standoff, but this is already doing the job well enough in my opinion. Using a ruler, the length turned out as 164mm, so it shrunk by 1 mm. It still fits but it's best to scale up the print by 0.5% as compensation.