Cutterblade (-holder)

A simple Cutterblade-holder.

To install a cutterblade you may need a lighter, a screwdriver and a pair of pliers.

1. Print the 2 parts and
2. heat the part around the hole in the cutterblade with a lighter.
3. Lay the cutterblade in the Handle like shown in the last picture (You should use a pair of pliers so you dont burn yourself). The blade should be under the nubs 1 and over the nub 2 (see picture).
4. Press down on the blade with a screwdriver so the blade melts into the nob 2.
5. Let it cool down and
6. press the blade under nob 3.
7. Test if the cap fits and press it on the blade so it holds tight.

Dont try to take out the blade after installation! Its difficult and dangerous! I assume no liability for injuries!