SLA printer piggy bank

This is simple piggy bank in the shape of a SLA printer.

Required hardware:

• 2 x M3 nuts
• 2 x M3 bolts (minimum length 16 mm)

Instructions:

Print both parts: the standard SPEED profile works well enough. Print the top part with the closed side down to prevent support/bridging. 

I can recommend orange and black, but a translucent filament may also work nicely for the top part! Additionally I can recommend the use of a textured build plate to give some texture to the top and bottom of the piggy bank.

Put top on bottom and insert the nuts in the slots. Then screw in the bolts via the side.

Note: the model does not fully flip open (as seen in the third picture): the thinner black piece of the back hits the top.

Dimensions (W x L x H): 75 mm x 75 mm x 150 mm