Features
- Support Mini-ITX motherboard
- Support ATX size PSU
- All parts are smaller than 220mm. Small printer bed friendly
- Support air cooler up to 50mm
- Support one 3.5 inch front bay for front I/O, or a floppy drive if you like :)
- No extra fan needed. All air flow is contributed by the CPU cooler and the PSU fan.
- Does not support discrete GPU
- There is no dedicated 2.5 disk slot, but I left plenty space above the PSU, where SATA SSD can be taped
Tools and Material you will need
- About 1kg of filament
- 85 hours of printing time (60mm/s, 0.15 mm layer height, 4 wall layers, 40% Cubic infill)
- 39 M3×4mm insert (get the kit that comes with a heat pressing tool)
- 33 M3×8mm screw
- 8 M3×12mm screw
- 4 #6-32 UNC screw for PSU mounting
- 2 keyboard switches for Power and Reset
- 2 5mm through hole LEDs and 2 4.7K ohm resistors
- Some wire and female jumper cable
- A soldering iron to heat press the M3 inserts and connect wires
- A 3.5 inch front I/O module
- Super glue
A detailed instruction is in the files.
License:
Creative Commons — Attribution — Share Alike
PuTaTuo
