Honda Civic EG/ Del Sol hood hinge boot (windshield cowl boot)

This is a model for the hood hinge/ windshield cowl boot for the Honda civic EG and Del Sol. It has a superb fitment and I modeled a little channel on the bottom to install with no glue needed! Just slip it into place and you're done.

PRINT SETTINGS:
TPU filament required since it's a flexible boot
I uploaded a 3mf file so it should be good to go but if you use a different slicer than me then just position the boots vertical and enable tree organic supports, it only needs support at the very base and everything else prints fine without.

If you would like to leave a tip for my hard work you can do so here :D  https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ