"Wireless Charger" - Nutricia Vertical Feeding Pump Stand

This was a quick design that allows you to utilise magnetic pogo connectors on a flexure to connect and disconnect a modified pump charger by just picking up the feeding stand - this is helpful for those who would like to feed at night without having to worry about disconnecting the pump-stand or running out of battery when getting up and moving.

Feet on the bottom of the stand protect the exposed contacts and allow for easy alignment with the base plate.

A cover on the bottom allows for the charging cable to leave out the rear, left or right of the stand.

The pump charging cable needs to be cut approximately 200 mm from the end of the lead and either end of this cut needs to be soldered to 2x2 of the available pogo pins - matching polarity.

I would recommend you understand what you're doing fully before modifying your pump stand or contact me for help!

I am hoping to redesign this soon to not require as much hardware and be two single printable pieces for easier sourcing and simplicity. As well as to be compatible with the backpack stand!

It utilises these low-cost magnetic pogo connectors: (https://www.aliexpress.com/item/1005005604764547.html?spm=a2g0o.order_list.order_list_main.48.256918026JjND6)

And some M3 brass inserts and hardware. (20 M3 Brass Inserts, 16 minimum)

The mount requires 4 M3 clearance holes to be drilled into the base of the pump stand or for the feet to be removed and the stand adhered in place - see the attached photo for hole dimensions/locations.