Loxodon, Elephantfolk Cleric 25mm (DND / TTRPG)

Here is a simple cleric Loxodon / Elephantfolk model although it could just as easily work as a wizard or sorceror or even a warlock or druid model - whatever you want :)! The trickiest part was sizing and positioning the staff so that it prints well and isn't a pain to clean supports off of without worrying about it snapping.

For this I did the usual thickening up and post processing to make sure it would print nicely.

I print using a 0.2mm nozzle at 0.08mm and 100% infill - usually with the models on their back (-90 degrees on the x axis) - in general, for best results, I would recommend using the version without a baseplate and then glueing the model to the baseplate but I print with the baseplate to show that it can be done.

Category: Other