Samsung Fridge Ice Drawer back wall extension

The Samsung french door fridge with ice-maker drops ice into two drawers. The back wall of the drawers is shorter than the sides, leaving a gap at the back that ice pours out of when you scoop it.

I made this clip in piece to extend that wall up so there is no longer anywhere for ice to fall out of the drawer.

Printing:

I like this printed in clear PLA.

It is cut in two pieces and joined with pins to get the best quality print.

Assembly:

See the photos of the best way to insert the pins: squeeze the middle, push in, drive home (half way), press on other side.

To connect to ice drawer: put the long flap inside the tray, clip the handle side under the existing “handle”, rotate into place, it should snap into place (make sure no ice is trapped behind the long flat - it is a snug fit)