Darkness cat bookmark

In the print project, the negative part is inserted. If you dont want a hole in the bookmark, remove it before the print.

If you use .stl and want “holes” in bookmarks, then add the negative part (cylinder) before print and adjust their size and location.

Model size is 50x150mm, You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. You may print at higher layer heights below the Min depth of 0.56mm. The Max Depth is 2mm and the Actual Depth is 2mm.

These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. 

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA Elegoo + Gray Transmission Distance: 3
PLA Elegoo + White Transmission Distance: 6
PLA Elegoo + Orange Transmission Distance: 6
PLA Elegoo + Yellow Transmission Distance: 4
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Gray
At layer #8 (0.72mm) swap to White
At layer #13 (1.12mm) swap to Orange
At layer #21 (1.76mm) swap to Yellow for the rest.