Long handle / extension for Boots Deep Tissue Percussive Massage Gun

Extended handle for Boots Deep Tissue Percussive Massage Gun (Boots is a British healthcare store, for those who don't know).

Print Settings

• Printer I used: White (handle) is on CR-10S, Black (bracket) was printed on an Ender 3,
• Filament: PLA,
• Layer Height: 0.2mm (0.3mm first layer),
• Nozzle Temperature: 210°C,
• Bed Temperature: 60°C,
• Supports: No,

The handle is a bit of a pain in the bum to print because it's so long. Needs a good bit of squish, and placed diagonally on a 300mm square bed.

Requirements

• 3x M3 heat set inserts (max length 5mm),
• 3x M3 washers (ones I had were 7mm OD),
• 2x M3 by 10mm bolts (in image are 12mm as it's what I had),
• 1x M3 by 30mm bolt (in image is 40mm as it's what I had).

All heat inserts go into the part of bracket which connects to handle (in the larger holes). It should be strait forward to build for most people. I may add assembly images later.

NB: I can only confirm that this is compatible with the Boots massager listed above. It attaches to pretty specific geometry on the body. I have had a look around a few places but not found a similar massager on any of the usual websites (ebay, AliExpress, Amazon & Temu).