Nextruder Nozzle Organizer for Prusa Core One

This is a Core One version of my Nextruder rack that was designed for the Original Prusa Enclosure.  This version attaches to the Core One using magnets and small hooks, and can be installed on either the left or right side.  Like the original design, these racks also have storage bins on top for holding miscellaneous tools and supplies.

There are 2 variations of the rack, holding either 4 or 7 Nextruder nozzles, and the nozzle holders accommodate heater blocks with silicone socks and nozzle adapters.

Each of the holders has a slot for inserting various identification plates.  A variety of identification plates have been included as a starting point, along with a couple blank plates (half height and full height) that can be used to add your own text in the slicer.

Required Parts:

6x2mm magnets (6 required for 7-slot rack, 4 required for 4-slot rack)

Miscellaneous Notes/Comments:

• The plates can be printed with either 0.2 mm or 0.15 mm layer height; I tried both, but since there are not many layers, there is no time benefit using 0.2 mm, so I used 0.15 mm.  Use a 0.4 mm nozzle due to the small text lines.
• Orient the rack on the build bed with the heater block slots down (on the bed) and the storage bins on top.  Print with 0.2 mm layer height using a 0.4 mm nozzle.
• Supports are required for the hooks on the top back edge.
• I printed my racks in PETG, but PLA will work fine in this application.
• If you would like to design your own plates the dimensions are 25mm W x 13mm H x 1mm D for the half height, and 25mm W x 26mm H x 1mm D for the full height.