Phone molle case holder (Samsung Galaxy S22-S25 ultra)
- no supports and no screws needed
- fit for Galaxy S22-S25 Ultra or similar size phones
- fit for phone with case
- cutout for buttons
Laser or normal molle versions
- Laser version has narrower molle straps and different dimensions of hinge, so you need to use correct size of pin
- 2 versions dimensions 4x5 and 5x4 molle (look on photo)
- 3 versions of hinge position (normal, 10mm or 25mm up)
Assembly
- It may seem like the hinge is stiff, but that's okay
- If the pin won't go in, clean it up a bit with sandpaper and use hammer to put it inside
- Put clips to holes
- Thread the rubber cord through the holes in the phone case.
Print settings
- 0,2 mm layer
- 8 walls
- no supports
License:
Creative Commons — Attribution — Noncommercial — Share Alike
43D PRINT
