Corolla E210 Touring Sport - Parcel Shelf Load Cover Extension mount clips

USE NEW V2 FILES
First version had split lower part for faster/easier reprint in case of broken part (again) but it turned out it is also super weak point of whole part at the same time.
New V2 version has lower part as one piece and thickened exposed places so it shouldn't break so easily as
the first (V1) version.

Models are positioned as they should be printed. Required supports are already on models.

Each side requires:

• 3x M3x10 (either socket or button head cap screw)

• 3x M3 nut

At least PETG should be used (I used ASA). I don't think PLA is good material for this purpose (due to potential hot conditions inside car).




In case you'd still want to use an old version, each side requires:

Models are positioned as they should be printed (clips needs supports).

• 2x M3x10 (either socket or button head cap screw)

• 1x M3x6 (button head cap screw preferred, but socket head cap screw may be used as well. In some cases 8mm length instead of 6mm might be necessary)

• 3x M3 nut