IKEA Skådis ( Skadis ) Bin lock

Are you tired that the bin's fall to the ground with only the lightest touch? So am i, So i designed this simple lock.
 

It comes in two parts, the hook on top that flexes and the distance that mounts lower down behind the bin to push it upwards against the lock

Print in PETG (I guess it works in PLA and other as well)
You need on of each per bin as well as a M3x8 bolt to lock the hook in place.

- INSTALL INSTRUCTION -
* Insert the bolt in to the hook so it flush with the back, then insert it in to the slot in the Skadis plate and push down to make it snap in place. 
* Tighten the M3x8 Bolt to make it lock in and can't fall out.
* Push in the Backing in to the Skadis board, this is thight and you need to push hard and wiggle it a bit but it will fit.

* Done !