Prusa Core One Thermometer/Hygrometer Holder

A thermometer/hygrometer holder that is installed inside the Prusa Core One enclosure using magnets.

This holder is designed to replace the stock case that comes with the thermometer/ hygrometer. It has a slim bezel for better visibility, a compact form, and a clean design.

Required other than printed parts:

• 5× 6x3mm magnets
• 1x Thermometer/hygrometer

Disassembly Thermometer/Hygrometer:
Press the two snap-fit tabs on each side (four in total) to release the fit, and then remove the internal parts.

Assembly: 
1. Reinsert the removed parts and snap the four snap-fit tabs into place. If fitting the back cover is difficult, you can try inserting the two snap-fit tabs marked in red in the image first, then gently tap the opposite side using a hammer and a mallet block.

2. Push a 6x3mm magnet into the hole and apply super glue if necessary. 

 Notes:

• It's necessary to adjust the scale factor to match the filament in use, considering material shrinkage. In my case, I use 100.5% for PETG and 101% for ABS.
• When disassembling or assembling the thermometer/hygrometer, removing the battery cover reduces the frame's rigidity and increases its flexibility, making the process easier.