COMPACT AND ELEGANT ENCLOSURE FOR THE NUKI KEYPAD 2.
Screws hidden on top + bottom for a cleaner look.
Additional parts needed:
Qty 2: M3x10 flat head screws (suggested with T10 torx drive)
Qty 2: M3 Nyloc nuts. These nuts should be pulled into the hex hole in the lid with a light press fit. You can use a long M3 screw (at least 25 mm long) that you first push through the outer hole of the lid. Then slightly thread the M3 nut onto it. Then pull it into the hex hole in the lid (making sure the hex is aligned properly). You can add a bit of hot glue into the nut pocket (from inside of lid) after pressing into place to keep them from falling out. Just make sure the glue doesn't stick out beyond the pocket for the nut. If necessary, clean up any excess glue once dried with an X-acto knife or razor blade.
ILAN SABAR
