Cord End Caps

An attractive cap that can be placed to secure the end of a paracord, drawstring, or other type of line.  Either use independently as something to grab at the end of a line, or use as a way to secure the end of a set of beads.  No supports are needed, and a layer height of .16 mm or lower is recommended (but not required).

To use, simply pull the line through the main piece with a small knot on the end, and then thread on the decorative cap.

As designed this is setup with a 6 mm hole on the end, which works well with paracord and drawstrings.  The source Fusion360 design file is also included though, which is setup in a fully parametric fashion so that it can be adjusted as needed.  If that is new to you, check out the explanatory video for one of my other models which is setup in a similar fashion.