Monitor Stabilizer for center monitor on arm

This is a stabilizer for a large monitor mounted on an arm. In this case it was a 34" Samsung monitor that I needed to add support for. The intention of this model was to make sure the joint on the arm did not droop under the weight of the monitor. It is rather crude, but it is a first attempt in OpenSCAD. It is overbuilt, but it just had to work, not look pretty.

The round area is 32mm in diameter. The small block at the opposite end  is about 26mm wide and was designed to sit in the gap between the two "teeth" on the back of the monitor to lock it in place.