Fog Lamp Mount for Toyota Sera (EXY10)

This is a custom-made bracket for attaching fog lamps to a Toyota Sera that did not come with a factory fog lamp.

Bill-of-Materials

• x2 M8 x 1.0 self-locking nut - Amazon (affiliate link)
• x2 M8 x 1.0 D 10mm bolt - Amazon (affiliate link)
• Fog Lamp Kit - Amazon (affiliate link)
• (optional) OEM Style Fog Lamp Switch - Amazon (affiliate link)

Print Instructions

• USING ASA FILAMENT IS STRONGLY RECOMMENDED. It will provide the best rigidity, UV, and temperature resistant as this part is used on the outside of the car.
• Print with your best settings for ASA.
• Walls: 6 walls
• Infill: 100% infill

Instructions to install

Follow these instructions at your own risk.

1. Assemble the fog lamps, and attach to the printed bracket.
2. Remove the under cover below the turn signal lamp. (There are two Phillips head screws.)
3. Move aside the under cover. Unscrew the turn signal lamp housing from the fender, and remove the turn signal lamp housing.
4. Insert an M8 nut into the printed bracket.
5. Place the printed bracket and align it to the hole visible from behind the tow hook weld point where the turn signal bracket was removed.
6. Thread in the M8 bolt, then tightened to desired torque and position.
7. Repeat for the other side.

No warranty expressed or implied.