Anytone AT-778UV Hand Mic Hanger

Neither files requires support. I printed mine in PETG as my radio is mounted in my vehicle and I've had PLA+ warp on me before on a hot day. PLA is fine if you're setting up your radio indoors. I attached the mount piece to my dash with a piece of double-sided foam tape (link below). I've used this tape multiple times for mounting prints in vehicles and have not had any failures yet.

When attaching the peg to the back of the mic, open the mic up first. The stock steel hanger is fastened with a loose nut from the inside and the nut can fall behind the circuit board, causing additional disassembly to be required. The peg will then fasten using the existing nut and screw from the original hanger.

This is my first upload here on Printables, so please post a “Make” if you end using these files as I'd love to see others get some use out of them!