2020 Cable Clips for Voron (fit LDO frame)

This is partially based on a design I saw - but can't find anymore...

Cable clips for the 2020 extrusions, they fit the LDO extrusions, can't check other ones.

Three versions:

"Full" is just a complete clip. Clips directly in or can be turned in. Can be twisted or pinched out again.

"Half" is what I used in the bottom electronics compartment of my Voron 2.4 - because the upper panel takes a bit of space the "Full" clip won't fit. This holds two stepper cables (8 wires total) easily.

"Mini with slot" is as small as I could make it. It is used to hold cables inside the extrusion slot itself. The slot is for a small screwdriver to turn the clip into, or out of, the extrusion.

Printed in ABS, only perimeters for flexibility. No supports but you need good bed adhesion for those small contact areas.

Print Settings

Printer Brand:

Prusa

Printer:

**Rafts:**

No

Supports:

**Resolution:**

0.2

Filament: Filament PM ABS

Category: 3D Printer Accessories