April 21, 2025
Description
Just a little container with screw-on top to hold some trail ribbon / marking ribbon. I use this while hunting to mark certain spots. One can tie something to the hole in the lid, I used a bit of Paracord and a small carabiner. The opening is large enough for 1-inch wide ribbon.
I've printed this in PLA with 0.2mm layer height and the thread works fine after screwing/unscrewing it a few times.
The Fusion 360 file is included. I've used a user parameter to set the height.
Category: Sport & OutdoorsLicense:
Creative Commons — Attribution
11
Stephan
