Vegepod cover mount for Eufy Solocam C210

This was designed for the Vegepod cover to mount a camera inside the cover, but should snap onto any vertical 16mm pole.

Print settings

• Material: PETG for the flex in the clips. PLA is fine but expect this to break after a few disconnections.
• Walls: 4
• Infill: 20% cubic, but I don't think it really matters that much.

Bill of Materials

You will need two M3x8mm (or longer) bolts and matching nuts to attach the camera.

On the camera, the part with the ball socket will pop out to give you enough room to connect the parts together.

Compatibility

Camera: The mount is a circular cutout 40mm in diameter, with a slot for mounting holes up to 20mm apart from the centre. I am pretty sure other Eufy models use the same component, but I don't have anything else to test with.

Pole mount: This will snap to any pole with a 16mm diameter. I tested this on a vertical and horizontal pole, however it doesn't balance very well with when mounted horizontally.

Other notes

There is a slight change to the latest uploaded version that removes sharp edges near the clips to avoid damaging your cover. The photos have my initial version that has a protruding section from the original remixed part.