Micron Dragonburner Beacon Probe mount

Had a Dragonburner laying around I wanted to mount on a Micron 180 with a Cartographer probe. 

Did not want to print Anthead since I do not want to open/break fans.

Dragonburner “alternative mounts” did not seem to have a Cartographer probe mount for the Micron.

Micron mount is compatible with Dragonburner and has a Beacon mount. 

Ran into 2 issues:

 1 - Dragonburner fans hit the belt loop. Spacer is required (spacers available for dragon alternative mounts)

 2 - Hole to pass hotend wiring on Micron+Beacon mount is really tight and almost did not fit in my case

I edited the Micron/Probe mounts and added 5mm. This does the exact same job as the Dragonburner spacers but at least it's built-in. 

I also enlarged the holes to pass the hotend wires. This might have been resolved by simply adding the 5mm, but I wanted to make sure the problem was fixed.

Logically you will need 5mm longer screws when attaching the toolhead.

Worked on my Formbot Micron kit with an early V8 Dragonburner