January 31, 2022
Description
This is a small case for all 0.7 x 1 inch adafruit boards.
The case is very delicate, please print with high details.
The lid is not designed to be constantly be taken apart, the clips will wear off very fast.
The board fits snug inside the case where it is held down by four pins / friction.
The two holes in the back of the case are used to push the sensor back out, using something dull like the tip of a retracted ballpoint pen.
The design allows to mount the sensor with a M3 countersunk wood screw.
License:
Creative Commons — Attribution
8
overcast
