May 19, 2025
Description
Remixed to use 8mm pogo connectors for those brave enough to do some soldering.
These are the specific ones I used but I'd imagine most of the 8mm ones on Amazon or Ali come out of the same Chinese factory. https://www.amazon.com/dp/B0D31Q12TH
Also added a couple alignment fangs to make sure you can't short the pogo without trying pretty hard.
Lid is unchanged from original but included here in case of upstream changes.
Slapped together quickly in TinkerCAD so no step files available.
2025-05-19: Applied the same changes to single fan side versions. Completely untested at this point.
License:
Creative Commons — Attribution — Noncommercial
7
Drakka01
