Safety 1st (safety first) baby / pet gate screw pressure plate holder insert

This inserts in the top of the gate and holds the pressure screw pad in place. The original part can slide out and get lost or damaged (as mine did). The 10.25mm version gave a snug fit for the screw for me, but there are a few sizes included if yours comes out too tight/lose.

Print settings

These are likely a bit overkill, but it doesn't add much print time or material.

• 5 perimeters
• 75% gyroid infill
• 10mm brim
• Support enforcers only on just on the free overhang (see picture)
• Printed in PLA+, any material should work fine

I also added the FreeCAD source where several things are parameterized. If the hole is too tight/loose you can tweak that parameter. I included a few sizes here if your printer makes the hole too tight/lose.