TP-Link Omada EAP Wifi Acces Point Vertical Stand

These TP-Link access points are supposed to be mounted on the ceiling but I'm renting so that's out of the question.

The access points work fine just placed on a surface but that looks messy and takes a lot of room too so I made these access point stands which look a bit better and give me some surface back.

Features:

• Big hole at back for Ethernet and power
• Chunky and  heavy: with 15% infill these used more then 550g each
• Circular cut-out to stop the access point rolling away

Print settings 

• Same as Prusa printed parts
• 15% infill, grid
• Brim recommended
• Tree supports recommended
• Important: print on side to strengthen the lip

Pictured: EAP-680. You can use the test fit file to print out the slot section and see if your model fits. It should fit any access point 35mm deep and 22cm diameter.