April 30, 2025
Description
Wall-mounted holder for aerosol cans, wd40, brake cleaner, carb spray etc..
REMIX:
Redid the magnetic holes to space magnets better for tolerance.
Extruded middle section, found this to be too thin for what I needed and made it a bit stronger.
Extruded hole for rear magnet, to be used instead of screw to wall option. Magnet to hang on toolbox or on side of lift, ladder, etc.
Requires:
https://a.co/d/aQbkbBT
Rear magnet if not screwing to wall, required (1) 60x10x3 magnet* as seen in pictures.
https://a.co/d/c151HCW
Glue : DAP rapid fuse super glue is my goto. A little drop is all that is needed.
https://a.co/d/2fRypt4
IMPORTANT:
Check that your slicer part position and height.
My slicer is Bambu Studio. Cura might not position it correctly on plate.
On bambu slicer I did use supports in order to support areas of cuts, suggest you add in cura.
License:
Creative Commons — Attribution — Share Alike
10
3dguy
