A stackable tray for Topre conical springs so they don't get tangled. The trays slide and snap to each other, keeping it secure and compact in storage. Each tray is a 8x5 grid and can store 40 springs.
Print settings
Material:
PETG recommended for a longer-lasting snap-fit.
PLA will work, but the snap-fit rails are likely to wear down over time which can cause the lid to loosen.
Layer height: 0.20mm. Smaller layer heights can work as well, but the clearances were designed for 0.20mm.
Supports: None
Orientation:
The tray should be printed with the bottom on the build plate.
The lid should be printed with the top on the build plate to improve the surface finish. It'll print just fine in the opposite orientation though.
Steven La
