Yaesu FT891 side rail MkIII

This is side rails for the Yaesu FT891 HF radio, they should be used with 4 pieces of M4x10 screws with washers(smaller than 10mm diameter). The frame will protect the buttons on the front during field operations or transport.

I recomend printing the frames using 3 vertical perimeters and 25% infill, with PETG.

M4x10 screws with washers will protrude 4mm into the radio.

Changes in MkII: 

• Siderail stretches back to cover the rear connectors on the radio

• Opening in right rail for the microphone cable

• Added small indent on the bottom side, to allow for the screw beside the mounting hole

Changes in MKIII:

• Added 0,75mm spacers around screw holes on both rails, so they go free of the front panels sides

Changes in Slim:

• Removed feet and fastening holes