Light Switch Arcade Button

Instructions

This conversion only works for rocker switches. New rockers with plenty of spring action work best. If you have toggle switches, you will need to change them out.

Box Assembly
Place all of your rings into the lid and set face down onto a flat surface. Only glue from the BACK SIDE (there is a photo for reference). Using a hot glue gun, lightly tack each ring in place making certain the ring and lid are fully together. Very little glue is needed

It's better to glue the lid and box together after the rings are already glued in place to make certain the lid will fit firmly into the box. With the lid still flat on the table, set the box on lid. Don't squeeze the wall sides while gluing since it may affect the fit onto the adapter plate. Lightly tack into place with hot glue.

Slip your buttons into the rings.

Slip the complete assembly onto the adapter plate starting with the bottom tabs and snap into place. The box should be flush with the wall. If there is a gap, remove the adapter plate, and screw the switches closer to the wall. If the tabs cannot snap onto the adapter plate then the switches need to spaced further from the wall.