Skadis iFixit Bit Set Holder

There are four brackets in total, one for each corner. Depending on your use case though, you might as well want to leave out the upper two. Especially if you plan on removing the set from the wall regularly.

The design is as low profile as possible since the back of the bit set is flush against the Skadis wall. 

Printing

All of the parts can be printed without supports and don't need any extra assembly since the hook is built in.

Printing these parts with standard strength settings should be decent to hold the box in place.

Attaching the Brackets to the Skadis Panel

Insert the two lower brackets into the holes in the panel and make sure they are three rows apart. Put the bit set in from the top. You can now attach the upper brackets if you want your bits to be firmly fastened.