RiteWing Spec DJI O3 Camera & ND Filter Protector

I created this mount so that I could mount a DJI O3 camera in the front nose of the VollStyle RiteWing. This mount should be printed in TPU and is designed to be a sung fit around the O3 camera module. I included screw holes on the inside if you decide to install them but I choose to leave them out, that way if the camera does hit something, then maybe it will give a little and side back some in hopes of saving the lens.  

Measure twice and mark the foam before cutting. Once an opening is made then cut a slit down both side so the side wings of the TPU mount can slide all the way in. This will help keep the camera centered and allow more surface area for E6000 to hold the TPU mount in place. I then choose to add a small piece of laminating film over the top and bottom for smoother air flow where they meet and a little extra strength.

3-4 walls 
15-20% infill should be fine
Print lens side facing up with supports