This stamp is built for leatherwork: it is designed with vertically tapered lines, which makes the model stronger and also easier to remove from wet leather. The back of the stamp has guide lines built in for perfect alignment.
Printing
- Face Up
- 100% infill
- Finer is better: .1mm layers is best
- No brim or supports
- PLA or PETG
Usage
- Soak some veg-tan leather
- Let the leather rest for several minutes
- Place the leather on a hard, flat surface
- Align the stamp on the leather
- Holding down one side of the stamp, firmly tap the leather with a wooden or pastic-headed mallet
- Repeat on the other side, top and bottom, and each quadrant
- Gently bend the leather off the stamp to remove
- Allow the leather to dry before continuing work
kame
