Revesible stand for Youloop and K-480WLA loop antenna

You will need about 1.4m of 20mm plastic conduit cut to the following lengths (cut a bit longer and adjust as neccesary):

• 1x 280mm and 1x 165mm for the two bottom spoke pieces
• 3x 280mm for the top and side spokes if you want it to be reversible, or
• 3x 300mm for the top and side spokes if you just want to use it for one antenna

You will also need 1x 4 way conduit box and lid for the centre. I tried a 3D printed shape but with 4 large holes it's too difficult to print.

Then you need to print the following pieces:

• 1x Hama Tripod Bracket (if you have a similar Hama tripod), or
• 1x Base (to screw to a wooden base for example)
• 1x Offset Bracket for the bottom spoke
• 1x Youloop Antenna End Caps (contains 3 pieces, 1x top end cap and 2x side end caps), and/or
• 1x K-480WLA Loop Antenna End Caps (contains 3 pieces, all the same)

Use an O-ring or an elastic band to secure the Youloop T-piece to the bottom spoke, and PVC glue to glue the end caps. Supports are required for the end caps and offset bracket.