Core One Vents-Automatic Vents V2

Smarter Airflow. Better Prints. Zero Effort.

Take complete control of your enclosure’s airflow and temperature—automatically. The CoreVent opens and closes in response to internal fan pressure, keeping heat stable for demanding materials like ABS, ASA, and Nylon.

Key Features

🌬 Pressure-Responsive – Rear exhaust fans trigger passive venting to regulate airflow and heat.

🔥 Superior Heat Retention – Stays sealed until airflow is necessary, preserving interior temps.

⚙ No Electronics Required – Fully mechanical system—no wires, motors, or maintenance needed.

📦 Easy Installation – Direct drop-in replacement for manual vent covers.

🛠 Manual Control Ready – Flaps can still be opened manually when desired.

What’s New With V2?

Built-in alignment guides for Ridged Placement

Improved flap seal with better-fit closing design

Added flap blockers for enhanced heat retention

Weighted flaps for more reliable automatic closing

Refined aesthetics for a cleaner, modern look

Printing & Assembly Tips

Matching Texture:
To replicate the original finish, enable Fuzzy Skin. Select the sides and back panels, then set:

Fuzzy Skin Thickness: 0.3

Fuzzy Skin Point Distance: 0.3

Flap Hinges:
Use short filament pieces as hinge pins. Align each flap at the center for a full seal. Clean or slightly enlarge the hinge holes if needed.

Closing Tip:
Leave about 2.5 inches of filament sticking out, then bend it at a 90° angle. This ensures the flaps close tightly and function as intended.